Multiva FX300 Comfort, Operation And Maintenance Manual

Page: 52 / 189

5. Washer M16 16 pcs
6. Locking nut M16 8 pcs
7. Plate 2 pcs
8. Hex screw M16x110 8 pcs
1. Set the scraper mounting plate (3) into place and fasten it by using washers (2), hex
screws (1) and locking nuts (4).
2. Repeat step 1 for the second mounting plate.
3. Fasten the plate (7) with washers (5), hex screws (8) and locking nuts (6).
4. Repeat step 3 for the second plate.
5.1.8. Mounting the rear harrow
The rear harrow is an accessory.
DANGER
The mounting of the rear harrow requires two people.
DANGER
Use a hoisting accessory when mounting the rear harrow.
Figure. 5.1.8. - 48. Mounting the rear harrow arms
Number Component Quantity
1. Locking nut M20 2 pcs
2. Washer M20 4 pcs
3. Hex screw M20x180 2 pcs
4. Hex screw M24x55 2 pcs
5. Hex nut M24 2 pcs
1. Attach the rear harrow arms to the seed drill with components (1-5).
Tighten the bolts of the rear harrow arms so that there is no clearance.
Operation and maintenance manual
FX300 and FX400 Comfort
1.00
52 (189)