Multiva Cerex 300 SeedPilot, Operation And Maintenance Manual

Page: 25 / 165

2884
2885
2886
3. C key
Table. 4.1.2. - 12. Display symbols
Symbol displayed Function
HA.1 Area I, partial area
HA.2 Area I, total area
| - - - - | Working width
o Advance
4.1.3. Using the counter
4.1.3.1. Setting the machine’s working width
The working width setting is 3 m. Enter the working width in metres.
1. Press the C key repeatedly until the working width symbol | - - - - | is displayed on the
screen.
2. Press the SET key.
The rst number starts to ash. The number can now be changed.
3. Press the C key repeatedly until the value is _.
4. Press the SET key, and the second number starts to ash. Press the C key repeatedly until
the value is 3.
5. Press the SET key, and the third number starts to ash. Press the C key repeatedly until the
value is 0.
6. Press the SET key, and the fourth number starts to ash. Press the C key repeatedly until
the value is 0.
4.1.3.2. Setting the value of advance
The advance is set to 150.0 cm. The value is entered in centimetres.
1. Press the C key repeatedly until the advance symbol o is displayed on the screen.
2. If the position of the comma must be changed, press and hold the SET key for
approximately 2 seconds until the comma starts to ash. Press the C key until the comma
is in the correct position.
3. Press the SET key.
The rst number starts to ash. The number can now be changed.
4. Press the C key repeatedly until the value is 1.
5. Press the SET key, and the second number starts to ash. Press the C key repeatedly until
the value is 5.
6. Press the SET key, and the third number starts to ash. Press the C key repeatedly until the
value is 0.
7. Press the SET key, and the fourth number starts to ash. Press the C key repeatedly until
the value is 0.
Operation and maintenance
manual
1.00 Cerex 300
24 (156)