MT5600BR-V92 Quick Start Guide
7
Installation
Perform the following procedure to install modem cards into the CC1600
rack. The installation process involves:
1. Verify that the DIP-Switch settings conform to your application
(dial-up or lease line).
2. Slide a modem card into one of sixteen available modem slots.
Start by inserting a modem into the left-most channel (slot #1) of
the rack. The toggle switch should be at the bottom of the card,
with the component side of the card facing the right. The modem’s
gold edge connector is offset so that the modem cannot be
inserted incorrectly. Continue installing modem cards as necessary.
3. Connect one end of an RS232C Cable to the appropriate modem
slot (DB25/25-pin connector-female) at the rear of rack. The other
end of the RS232C cable is connected to the serial port of the
computer.
Note: Any cables connected to the computer must be shielded to
reduce interference.
4. Plug one end of the RJ11 cable provided with the modem into the
rack's RJ11 connector (located on the back plane of the modem
rack) and the other end into the phone-company-provided RJ11 or
RJ11W modular phone jack.
5. Verify the remote modem's current configuration settings with your
MT5600BR-V92 in terms of data compression, error correction,
transmission rate, etc. Refer to the AT commands Reference
Guide on the product CD.
6. Make sure modem and computer/terminal serial port baud rates
are adjusted.
7. Proceed to Chapter 3 in the User Guide, or to your data
communications software manual for additional modem
configuration.