Multitech MT-SMI-DK, Development Manual

Page: 34 / 68

CHAPTER 6 – LABELING REQUIREMENTS
Universal Socket Developer Guide 34
Chapter 6 – Labeling Requirements
Cellular Approvals and Labeling Requirements
Note: For MTSMC LTE models, refer to the MTSMC-Lxx Device Guide for labeling requirements.
Approvals and Certification
The Multi-Tech SocketModem is an industry and/or carrier approved modem. In most cases, when integrated and
used with an antenna system that was part of the Multi-Tech modem certification, additional approvals or
certifications are not required for the device you develop as long as the following are met. Note that EV-DO
modems have a few exceptions.

PTCRB Requirements (EDGE, GPRS and HSPA/HSDPA only)
The antenna system cannot be altered.

Model Identification
The Multi-Tech model identification allows the carrier to verify the modem as one of its approved models.
This information is located on the modem's label.
Note: Both the host device and modem include labels. When the cellular carrier asks you to provide the
modem's model identification, give the Multi-Tech cellular model identification, not the host device
model. The ESN or IMEI number on the host device label will match that of the modem.

For C1, C2, and EV3 SocketModems: The modem's MEID (Mobile Equipment Identifier) written in
hexadecimal format is printed under the barcode on the modem.

For EV2: The modem’s ESN (Electronic Serial Number) is printed below the barcode.

For G2, G3, H3, and H5 SocketModems: The modem's 15-character IMEI (International Mobile Equipment
Identity) number is printed on the modem's label.
Example GPRS End Product Label
Note:
Actual labels will vary depending on the regulatory approval markings and content.
Host Device Model Identification
Multi-Tech SocketModem
Model Identification
IMEI Number