Multitech Dragonfly MTQ-LEU7, Device Manual

Page: 28 / 36

USING CONNECTION MANAGER
28 Dragonfly
TM
MTQ-LEU7 Device Guide
8. To specify a folder for Connection Manager, use the default folder or click Change to browse to the folder
you want to use.
9. Click Install .
A separate wizard opens for installing Telit drivers. Some MultiTech devices use embedded modules from
Telit Wireless Solutions to provide cellular connectivity; these devices require Telit drivers.
10. Select Complete setup type.
11. When the drivers are installed, click Finish .
12. In the Setup Wizard, click Finish .
Note:
To open Connection Manager after installation, check Start the MultiTech Connection
Manager when the installation is finished .
After the drivers are installed, you need to restart your computer if prompted by Windows.
If using a USB device, you can connect the device to the carrier's network with Connection Manager. Refer to
Connecting a Device .
If using a serial device, you need to set up the device in Windows Device Manager before connecting the device.
Refer to
Setting Up a Serial Device in Windows Device Manager .
Setting Up a Serial Device in Windows Device Manager
To set up the device in Windows Device Manager:
1. Make sure that your desired COM port for the serial device is available.
2. Connect the serial device to the PC.
3. Go to Control Panel > Device Manager . Make a note of the COM port number for the connected device
(in COM Ports ).
Example: The COM port is COM31 .
4. Go to Action > Add legacy hardware .