Multistore Compact Series, Assembly Instructions Manual, Page: 4 / 7

DRAWER ASSEMBLY 4 DRAWER INSTRUCTION
STEP 1.
LAYOUT YOUR DRAWER PIECES FLAT AS PER DESIGN WITH PRE -
DRILLED HOLES FACING UP.
START WITH THE BACK OF THE FRONT DRAWER AND PLACE YOUR
DOWELS & CAM PIN IN THE PRE
- DRILLED HOLES ON EITHER SIDE AS
INSTRUCTED BELOW
.
NO MODEL DESCRIPTION QTY
6 CAMS 8
7 CAM PINS 8
8 30mm 8 GAUGE SCREW 3
9 EURO SCREWS 16
10 HANDLE 4
11 RUNNERS PER SET 4
NO MODEL DESCRIPTION QTY
1 CONFIRMAT SCREWS 16
2 DOWELS 16
3 BACKING NAILS 80
4 5/8 X 6 WOOD SCREWS 24
5 INFILL 1
STEP 2.
G
RAB
YOUR FIRST SIDE AND INSERT YOUR CAMS INTO THE HOLE
PROVIDED ON THE OUTSIDE OF THE DRAWER GENTLY AS PER
INSTRUCTIONS BELOW
PUSH THE SIDE INTO THE FRONT DOWELS & PIN AND THEN CAREFULLY USING A SCREW DRIVER TURN UNTIL IT LOCKS IN. RE-
PEAT THIS PROCESS WITH THE OTHER SIDE.
NOW PLACE YOUR LAST PIECE BETWEEN THE TWO SIDES USING THE SCREWS SUPPLIED SCREW
INTO THE SIDES OF THE BACK DRAWER PIECE.
IMPORTANT NOTICE:
PLACE THE FITTING OVER THE HOLE KEEPING THE
SQUARE EDGE OF THE FITTING PARALLEL TO THE
FACE OF THE BOARD, KNOCK IN CAREFULLY.