WM-90 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/10/04) — PAGE 27
WM-90 PLASTER/MORTAR MIXER — OPERATION
Stopping the Mixer (Gasoline Engine)
1.
Place the
belt slip lever
in the
start/stop
position
(Figure 21).
2.
Push the main
start/stop
switch (Figure 16) inward to
stop the engine.
3.
Turn the fuel shut-off valve to the
OFF
position.
4.
Disconnect the spark plug.
5.
Clean mixer as referenced in the maintance section of
this manual.
Stopping the Mixer (Electric Motor)
1.
Place the electric motor's
ON/OFF
switch (Figure 7) in
the
OFF
position.
2.
Disconnect the electric motor's extension cord from its
power source.
3.
Clean mixer as referenced in the maintance section of
this manual.
NEVER
disable or disconnect the start/stop switch. It is
provided for operator safety.
Serious Injury
may result if
it is disabled, disconnected or improperly maintained.
DANGER
DANGER
DANGER
DANGER
DANGER
It is recommended that the mixer's
Start/Stop switch
be used to stop
the engine after every use.
Doing this will verify that the switch is working properly and
presents no danger to the operator.
NOTE
DO NOT Disconnect
the Start/Stop Switch
