MQ STOW MS18H/MS18E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06) — PAGE 9
■
Stop the engine when leaving the mixer unattended.
■
Block the unit when leaving or when using on a slope.
■
Maintain this equipment in a safe operating condition at all
times.
■
ALWAYS
stop the engine before servicing, adding fuel and
oil.
■
NEVER
Run engine without air filter. Severe engine may
occur.
■
ALWAYS service air cleaner frequently to prevent carburetor
malfunction.
■
ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using mixer.
■
ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■
DO NOT operate this equipment unless all guards and safety
devices are attached and in place.
■
CAUTION must be exercised while servicing this equipment.
Rotating and moving parts can cause injury if contacted.
■
When towing, an adequate safety chain must be fastened to
the frame, refer to page 19.
■
Keep all
inexperienced and unauthorized people away
from the equipment at all times.
■
Unauthorized equipment modifications will void all warranties.
■
Check all fasteners periodically for tightness. Also check
towing tongue bolt, lock nut and wheel lug nuts for wear.
■
Stop the engine and disconnect the spark plug before allowing
anybody’s hands in the mixing drum.
■
NEVER pour or spray water over the engine or electric motor.
■
ALWAYS
stand clear of dump handle when mixer is in
operation. Any binding of material between the mixer blades
and drum will cause drum and handle to quickly move in the
discharge position.
■
Depending on type of mixer, test the
ON/OFF switch for either
the gasoline engine or electric motor before operating. The
purpose of these switches is to shut down the engine or motor
of the mixer.
■
Refer to the
HONDA Engine Owner's Manual for engine
technical questions or information
recommended by Multiquip
for this equipment. Damage to the equipment and/or injury to
user may result.
Transporting
■
ALWAYS
shutdown engine before transporting.
■
Tighten fuel tank cap securely and close fuel cock to prevent
fuel from spilling.
■
Drain fuel when transporting mixer over long distances or
bad roads.
Maintenance Safety
■
NEVER lubricate components or attempt service on a running
mixer.
■
ALWAYS
allow the mixer a proper amount of time to cool
before servicing.
■
Keep the mixer in proper running condition.
■
Fix damage to the mixer immediately and always replace
broken parts.
■
Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
■
DO NOT use food or plastic containers to dispose of
hazardous waste.
MS18H/MS18E MIXER — RULES FOR SAFE OPERATION
Go to Discount-Equipment.com
to order your parts
