PAGE 48 — DCA-400SPK — PARTS AND OPERATION MANUAL— REV. #0 (06/19/01)
4. Close all engine enclosure doors (Figure 34).
Figure 34. Engine Enclosure Doors
5. Set the battery ON/OFF switch (Figure 35) to the ON
position.
Figure 35. Battery ON/OFF Switch
2. Connect the load to the UVW terminals as shown in
Figure 32. These terminals can be found on the output
terminal panel, see page 35 Figure 14. To gain access
to the output terminals lift the UVW cover. Make sure to
tighten terminal nuts securely to prevent load wires from
slipping out.
Figure 32. UVW Terminal Lugs (Load)
DCA-400SPK — GENERATOR START-UP PROCEDURE (MANUAL)
NEGA
TIVE
POSTIVE
BATTER
Y
3. Connect the negative battery cable (BLACK) to the
negative post on the battery (Figure 33).
Figure 33. Battery Connections
6. When starting the generator in
COLD
weather conditions,
press and hold the engine preheat button (Figure 36)
until the preheat lamp (Figure 37) is lit (ON).
Figure 37. Engine Pre-Heat Lamp
Figure 36. Engine Pre-Heat Button
Summary of Contents for Power WHISPERWATT DCA-400SPK
