DCA-20SPX— OPERATION AND PARTS MANUAL — REV. #2 (04/14/10) — PAGE 37
1
1. Perform steps 1 through 5 in the
Before Starting
section.
2. Place the
MPEC Control Switch
(Figure 41) in the
AUTO
position
3. Continue operating the generator as outlined in the
Manual Start-up
Procedure
(start at step 3).
Figure 41. MPEC Control Switch (AUTO)
When the generator is set in the
AUTO
mode, the generator will
automically start
in the event of
comercial power falling below a
prescribed level by means of a
contact closure that is generated
automatically by a transfer switch.
NOTE
Starting (Auto Mode)
Before connecting this generator to any
building’s electrical system, a
licensed
electrician
must install an
isolation
(transfer)
switch
. Serious damage to the
building’s electrical system may occur
without this transfer switch.
DANGER - ELECTRICAL SYSTEM HAZARDS
When connecting the generator to a isolation (transfer)
switch,
ALWAYS
have power applied to the generator's
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.
CAUTION - BACKUP GENERATOR USE
When running the generator in the
AUTO
mode, remember
the generator can start up at any time without warning.
NEVER
attempt to perform any maintenance when the
generator is in the auto mode.
WARNING - AUTO MODE MAINTENANCE
DCA-20SPX — GENERATOR START-UP PROCEDURE (AUTO MODE)
When starting generator in
AUTO
mode use the "
Manual
Start-up
" procedure except where noted (see below).
Summary of Contents for Power WHISPERWATT DCA-20SPX
