© COPYRIGHT 2005, MULTIQUIP INC.
Montreal, Canada • Manchester, UK
Rio De Janeiro, Brazil • Cipsa, Mexico
MULTIQUIP INC.
POST OFFICE BOX 6254 • CARSON, CA 90749
310-537-3700 • 800-421-1244 • FAX: 310-537-3927
E-MAIL: [email protected] • WWW: multiquip.com
Figure 6. On Off Switch
Figure 5. Fuel Shut-Off Valve (ON)
2.
Set the engine ON/OFF switch (Figure 6) to the "
ON
"
position (start).
Initial Start-up
When starting the MT-65HA Tamping Rammer perform the
following:
1.
Open the
fuel shut- off valve
by moving the
fuel cock
lever to the
open
position (Figure 5).
Figure 8. Choke Lever
Figure 8. Recoil Starter
6. If engine fails to start, move the choke lever (Figure 8) to
the half open position to avoid flooding.
7. Repeat steps 1 thru 6.
8.
If the engine does not start after repeated attempts,
check the spark plug for excess fuel. Clean and re-
place the spark plug as needed.
Operation
1. To start the rammer tamping action, move the throttle lever
(Figure 9)
quickly
from
IDLE
(close) to the
FULL OPEN
position .
DO NOT
move the throttle lever slowly as this
may cause damage to the clutch or spring.
Figure 9. Throttle Lever (Full Open)
Stopping The Engine
Normal Shutdown
1. Move throttle lever quickly from the
FULL OPEN
to
IDLE
position (Figure 7) and run the engine for three minutes
at low speed.
2. Close the
fuel shut- off valve
(Figure 5) by moving the
fuel cock lever to the
CLOSED
position.
Emergency Showdown
1. Move the throttle lever quickly to the
IDLE
position, and
turn the engine start/stop switch to the
OFF
position. Turn
fuel valve lever to the
CLOSED
position.
3. After the engine
cools
, turn the engine start/stop switch to
the “
OFF
” position (Figure 6).
3. Move the throttle lever to the "
IDLE
" position (Figure 7).
Figure 7. Throttle Lever (Idle)
4. In cold weather, start the unit with choke lever
"Fully
Closed"
(Figure 8). In warm weather or when the engine
is warm, the unit can be started with choke halfway or
completely
open
.
5. Grip the recoil starter (Figure 9) handle and pull it until you
feel a slight resistance. Then pull sharply and quickly.
Return the recoil starter handle to the starter case before
releasing.
