![background image](http://html1.mh-extra.com/html/multiquip/mikasa-mvc-40g/mikasa-mvc-40g_operation-and-parts-manual_1855338014.webp)
l
PAGE 14 — MVC-40G PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #4 (06/06/07)
MVC-40G — COMPONENTS (ENGINE)
Figure 4. Engine Controls and Components
INITIAL SERVICING
The engine (Figure 4) must be checked for proper lubrication and
filled with fuel prior to operation. Refer to the
ROBIN
engine service
manual for instructions and details for proper operation and servicing.
9
.
Carburetor –
Regulates fuel flow.
10
. Oil Dipstick/ Filler Cap–
Remove the filler cap dipstick
when checking the engine oil level. Add engine oil through
this filler port. See Table 4 for recommended type engine
oil.
11
. Oil Drain Plug –
Remove this plug to drain engine oil from
the crankcase.
12
. Muffler –
Used to reduce noise and emissions.
ALWAYS
allow a sufficient amount of time for the muffler to cool before
touching.
Operating the engine without an air
filter, with a damaged air filter, or a
filter in need of replacement will
allow dirt to enter the engine,
causing rapid engine wear.
NOTE
1
.
Throttle Lever –
Used to adjust engine RPM. Push lever
upwards for
SLOW
, and down for
FAST
.
2
.
Recoil Starter (pull rope) –
Manual-starting method. Pull
the starter grip until resistance is felt, then pull briskly and
smoothly
3
.
Air Cleaner –
Prevents dirt and other debris from entering
the fuel system. Release clips on side of air filter cannister
to gain access to filter element.
4
.
Fuel Valve Lever –
OPEN
to let fuel flow,
CLOSE
to stop
the flow of fuel.
5
.
Choke Lever –
Used in the starting of a cold engine, or in
cold weather conditions. The choke enriches the fuel
mixture.
6
.
Fuel Tank –
Holds .40 gals (1.5 liters)unleaded gasoline.
For additional information refer to ROBIN engine owner's
manual.
7
.
Fuel Filler Cap –
Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely.
DO NOT
over fill.
8
.
Start/Stop Switch –
Place this switch in the "ON" position
(1) to start the engine. Place in the "OFF" position (0) to
stop the engine.
Engine components can generate extreme heat.
To prevent burns,
DO NOT
touch these areas
while the engine is running or immediately after
operating.
NEVER
operate the engine with the
muffler removed.
Warning - Hot Surface
13
. Spark Plug –
Provides spark to the ignition system. Set
spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch)
Clean spark plug once a week.