MAYCO ST-45HRM PUMP — OPERATION & PARTS MANUAL — REV. #4 (07/16/04) — PAGE 29
ST-45 PUMP — INSPECTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
NEVER
operate the pump
in a confined area or
enclosed area structure
that does not provide
ample
free flow of air
.
ALWAYS
wear approved
eye
and
hearing
protection before operating the pump .
NEVER
place hands or feet inside the
hopper
.
ALWAYS
make
while the engine is running.
ALWAYS
shut-down the engine
before performing any kind of maintenance service on the pump.
NEVER
operate the pumps's engine with the
engine hood removed. The possibility exists of
hands
,
long hair
, and
clothing
becoming
entangled with the V-belt, causing injury and
bodily harm.
Before Starting
1. Read safety instructions at the begin-
ning of manual.
2. Clean the
entire pump
, removing dirt and dust, particularly
the engine cooling air inlet, and air filter.
3.
Check the
air filter
for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4.
Check fastening nuts and bolts for tightness.
FUEL CHECK
5.
Read the fuel sight tube (Figure 10) on top of the fuel tank
to determine if the pump's engine fuel is low .
See Figures 5 & 6 on pages 20-22 for
the location of any control or
component referenced in this section.
CAUTION:
Handle fuel safely. Diesel fuel is highly
flammable
and can be dangerous if
mishandled.
DO NOT
smoke
while refueling.
DO NOT
attempt to refuel mixer if the engine is
hot or running.
ALWAYS
allow engine to
cool
before refueling.
Figure 11. Adding Diesel Fuel
NOTE
Figure 10. Fuel Sight Tube
6.
If fuel is low, remove fuel filler cap and fill with
#2 diesel
fuel
(Figure 11).
