PAGE 14 — DSGPULW DUOSCREED — OPERATION AND PARTS MANUAL — REV. #7 (09/19/18)
l
DSGPULW DUOSCREED — COMPONENTS (HONDA GX35SAT ENGINE)
1
.
Spark Plug –
Provides spark to the ignition system. Set
spark plug gap to 0.6 - 0.7 mm (0.024 - 0.028 inch) Clean
spark plug once a week.
2
.
Muffler –
Used to reduce noise and emissions.
DO NOT
touch muffler while engine is running, let engine cool before
performing any maintenance.
3
.
Spark Arrester –
Prevents sparks from leaving the engine
exhaust system, which could ignite flammable materials.
4
.
Starter Grip –
Grip this handle to start engine. See engine
starting section of this manual.
5
.
Recoil Starter (pull rope) –
Type of engine starting method.
6
.
Oil Filler Cap –
Remove this cap to add engine oil. Engine
oil capacity is 0.11 quart (0.1 liters). Use SAE 10W-30.
7
.
Fuel Tank –
Holds .65 liters (approximately .172 gallon)
of
unleaded gasoline.
8
.
Fuel Filler Cap –
Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tighten securely.
DO NOT
over fill.
9
.
Priming Bulb –
Used in the starting of a cold engine or an
engine that has run out of fuel. Press the priming bulb
repeatedly until fuel can be seen inside the clear plastic
bulb.
10
. Air Cleaner –
Prevents dirt and other debris from entering
the fuel system. Release latch on side of air filter
compartment to gain access to filter element.
11
. Choke Lever –
Used in the starting of a cold engine, or in
cold weather conditions. The choke enriches the fuel mixture
for starting a cold engine.
Figure 2. HONDA GX35SAT Components
