![background image](http://html1.mh-extra.com/html/multiq/42ds/42ds_user-manual_1854945010.webp)
9 - English
5. Hardware Installation
5-1. Installation
1. Power off both the Computer/equipment and Monitor before making any
connections.
2. Install monitor on a solid surface such as a VESA metal.
3. Connect the power cable to the back of the LCD monitor.
4. The LCD monitor connection.
a)
Analog signal (D-sub 15 pin Cable):
There is one set analog signal input (VGA-IN) and output (VGA-OUT)can be
used.
VGA-IN is for analog signal input, connect the signal cable on the rear of the
monitor to the 15-pin connector on the rear of the computer.
VGA-OUT is for analog signal output, connect the signal cable connector
from this monitor to input connector of another monitor.
Note: This LCD monitors DOES NOT require any special drivers. Necessary
drivers are supplied by the graphics card manufacturer and may be found on
the diskettes/CD supplied with the graphics card that came with your
computer. Windows drivers for both the monitor and the graphics card are
supplied on the Windows CD or diskettes. You may use the standard
resolution 1920x1080@60 as the monitor type. The graphics card must also
be set up correctly in Windows and make sure the video output of the
graphics card is listed in Section 6.1 or check your Graphics card manual or
Windows ReadMe file for further information on Graphics card. HDMI signal.
b). HDMI signal
Connect the HDMI connector from the back of the equipment to the HDMI
connector located on the back of the display.
If the external device has DVI output only, use a DVI to HDMI adapter cable
to connector to the HDMI terminal.
Summary of Contents for 42DS
Page 1: ...42DS 52DS TINSE3245Y1 ...