INST
ALL
ATION
Cop
yrigh
t © 2020 Multilink I
nc
. A
ll righ
ts r
eser
ved • Sp
ecific
ations subjec
t t
o change without notic
e • Re
v. 8/10/2020
© Multilink Inc. 2020
•
All Rights Reserved
Page 5
Do
cumen
t N
o. Retr
o-F
it I
nstr
uc
tion
4. Deep Frame Retro-Fit Installation
4.1 Remove Existing Frame
Remove original frame screws and then remove
existing frame.
4.2 Assembling Frame
Assemble Deep Frame similarly to how the
Standard Frame is assembled. For larger than 15" unit,
attach frame braces to the base of the frame sections'
intersection.
4.3 Install Deep Retro-Fit Frame
Place Retro-Fit Deep Frame over base flanges and
line up mounting holes, secure with supplied frame screws
and test doors for functionality. If expansion kit is also
being applied there are brackets that connect the two
doors together so they act as one, it is up to the customer/
installer how they would like the doors to operate.
If you experience difficulty during frame installation
with the doors attached then unsnap door(s) from Multi-
Media Distribution Enclosure frame hinge to allow for an
easier frame installation. Position the MDE door frame on
to the recessed base. Attach the MDE frame to the base
of the enclosure using the supplied #6 x 3/8" flat head
screws. Before attaching the door to the frame install any
additional hardware such as a latch (See 6.1) or cam lock kit
(See 6.2). Finally attach the door(s) to the frame using the
hinge system located on the left side of each door.
072-724-10
30" Retro-Fit Deep Frame Kit
