13
www.
multilaser
.com.br
12
Dismantling:
Insert the dismantling key into the key hole of device until the hook
lock is open, then get the device and key out.
Troubleshooting
If you come up against some problems shown in the following
table, please first check if wires are properly connected. If wi-
res are properly connected but there are still problems, please
contact the nearest service agents and do not disassemble the
machine by yourself.
Faults
Analyze Causes
Solutions
Failure of being
powered on
It is not powered
on
If the vehicle
power is properly
installed, turn the
shift knob to ACC.
Fuse is burnt.
Make sure no
short circuit
occurs on the line
and replace the
fuse.
It is mute or the
volume is at zero.
Adjust the volume
to your required
level.
Wires are impro-
perly connected.
Check the wiring
diagram and make
sure wires are
properly connec-
ted.
Poor contact
Please pull out
the device and
reinsert it.
Noises and sound
distortion
Speaker cables
are pressed by
screws.
Check the speaker
cables.
Speaker cables
are short-circui-
ted.
Properly connect
wires.
Failure of Radio
Antenna is not
pulled out or con-
nection is wrong.
Properly connect
the antenna and
pull it out as long
as possible.
Weak signal
Rotate the an-
tenna to proper
direation.
Stop working
CPU can not work
normally.
Turn off the power
and power it on
again.
Files are dama-
ged.
Skip this file and
please select next
file.
Specifications
FM
Tuning range
FM tuning interval:
100 kHz
switchable
87.5 ~ 107.9 MHz
(at 100 kHz step)
Aerial terminal
External aerial connector
Intermediate frequency
10.7 MHz
Usable sensitivity
11 dBf
Selectivity
75 dB em 400 kHz
Signal-to-noise ratio
65 dB (stereo), 68 dB (mono)
Harmonic distortion at 1
kHz
1 kHz
0.7 % (stereo), 0.5 % (mono)
Separation
33 dB at 1 kHz
Frequency response
30 ~ 15,000 Hz
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
Speaker impedance
4 ~ 8 Ω
Maximum power output
45 W 4 (em 4 Ω)
General
Outputs
Audio outputs
Power aerial relay control
lead
Tone controls
Bass ±9 dB at 100 Hz
Treble ±9 dB at 10 kHz
Power requirements
12 V DC car battery
(negative earth)
Dimensions Approx.
178 x 50 x 130 mm
Mounting dimensions Approx. 187 x 57 x137 mm
Mass
Approx. 0.6 kg
Note:
This unit cannot be connected to a digital preamplifier or an
equalizer. Design and specifications are subject to change
without notice.