Operate Junior Racer Whoop Drone
*Power On/Off:
connect the power cable of to
Junior Racer 75 the battery, the power LED,
receiver LED and FC LED are on, then the FC LED flashes and the receiver LED turns off. After
using, unplug the connection, and all LED will turn off.
*Battery:
connect the battery to the voltage tester to display the current voltage value of the
battery.
*Charge:
connect the battery to the charger supplied with the adapter or other 5V power.
The LED will show red light when charging; the LED will show green light when finishing
charging.
F411 12A AIO FC
FC Parameters:
CPU: STM32F411CEU6 (100MHZ)
Six axis: MPU6000 (SPI connection)
Size: 26mmx26mm
Firmware version: BetaflightTCMM-F411
RC sharing: UART1-RX
OSD: Built-in BetaflightOSD (STM32 controls the OSD chip through SPI in DMA mode)
Receiver: Support FrskyXM/XM+ receiver/Futaba receiver/Flysky receiver/TBS Crossfire
receiver
Support programmable LED such as WS2812
Built-in current sensor
Reserved buzzer interface
Reserve DJI port
Weight: 5.07g
ESC Parameters
Support: BLheli/BLHELI_S
Support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
Input voltage: 2S-4SLipo
Continuous current: 12A
Peak current: 13A
Firmware: BLHELI_S
Processor: SILABSEFM8BB21F16G
Motor connector: 1.25mm pin header connector
Factory firmware: GH-30-16.7
