Instruction Manual, SL2150 Series
FEATURES and OPERATION 4
REV A, Sep 21, 2011
1V to the polarity power voltages to offset any voltage drop caused by long coax cable runs.
This change in LNB voltage will also be reflected on the
Power Status
screen. An example
of the
Link Config
screen is shown below:
RECEIVER, SL2150-FRX
The receiver module front and back is shown in Fig 2.
The FRX front panel features and functionality are identical to those of the FTX. The rear
panel has the same
POWER
input as the FTX. The
OPTICAL INPUT
connector is for
connecting the fiber from the FTX. As with the FTX, use only fibers with APC connectors. The
RF-OUT
connector is for connection of a 50 or 75 ohm coax for your L-band RF output. As
with the FTX, connector types are dependent on model.
The FRX display screens are similar to those of the FTX with the exception that there are
only 3 screens:
Power Status
,
Link Status
, and
Display Config
. Navigation is as described
in the FTX section. The
Display Configuration
screen is identical to that of the FTX. The
Figure 2. Front and Back of SL2150-FRX
