I N S T A L L A T I O N
The following section covers installation
of your Versa-Link ATX-250 in various
applications.
Your “ATX-250 INSTALLATION MANUAL”
contains more detailed information about
most telephone systems and
applications.
NOTE: You may want to call a local
telephone service company (listed in the
Yellow Pages under “Telephone
Equipment and Service”) to install the
necessary jacks between the telephone
company's line and your internal wiring.
5.
1
I N I T I A L
C H E C K - O U T
Your ATX-250 shipping carton should
contain the following equipment
- Your Versa-Link ATX-250
- An AC wall transformer with cord
One modular telephone cable
Plug the 12 Volt AC wall transformer into
an electrical outlet (110 Volt AC, 50-60
Hz) and plug its power cord into the
power connector on the back of your
ATX-250. The
LED
indicator on the front
of your ATX-250 should now be lit,
showing that power is on and the
ATX-250 is operating.
5 . 2 C O N N E C T I N G T O
T H E P H O N E L I N E
WHAT LINE DO I
LINE DO I USE?
Locate and identify the telephone line to
which you plan to attach your ATX-250. If
you are using a multi-line telephone
system with rollover, use the last line in
the rollover sequence.
WHERE DO I CONNECT MY ATX-250?
Locate a point on the line between the
telephone company and all existing
telephone equipment and extensions
attached to this line. Disconnect all
telephone equipment and extensions
from the telephone line. They will later be
re-connected to the telephone line
THROUGH your ATX-250. You may need
to install RJ-11 jacks to facilitate
installation of your ATX-250.
IMPORTANT: One function of your A T X
250 is to receive incoming calls and then
distribute them to the proper equipment.
For this reason it is VERY important that
your ATX-250 be installed ahead of all
existing telephone extensions and
equipment.
Attach the incoming telephone line to the
LINE
connector on the back of your
ATX-250. The
should now be
the only device connected to this
telephone line.
5 . 3 R E - C O N N E C T I N G
Y O U R T E L E P H O N E
S Y S T E M
If you are using this line for voice
communication, you will need to
reconnect your telephone system
THROUGH THE ATX-250. First, you will
want to determine what type of phone
system you have.
VERSA-LINK ATX-250
