TO ENTER PROGRAMMING MODE
To enter programming mode, pick up the receiver of the phone that is plugged into device port 1 and dial **7764#. After dialing
the string, 3 quick high beeps should be heard. This affirms entry into the programming menu.
To program individual registers, press the register number you wish to program and the desired digits immediately in a
contiguous string (as an example: 023 to set register 02 to a value of 3). If an error in entry is detected, a single low pitch beep
will be heard followed by a short space, then 3 quick high beeps. The 3 quick high beeps tell you to select the next register in the
menu for programming.
TO RESET ALL REGISTER VALUES TO ACTORY PRESET
Press 60 while in programming mode to reset all registers to factory defaults.
TO READ VALUES FROM MEMORY
Press 70 on your telephone keypad.
TO WRITE PROGRAMS TO MEMORY
Press 80 on your telephone keypad.
This should always be done when you
are satisfied with the information you
have programmed.
To EXIT PROGRAMMING MODE
Press 90 on your telephone keypad.
