tint-REMOTE CONTROL
42
INSTRUCTION MANUAL
5. Hold down the group button again until the selected bulb starts to blink again.
The group display for group 1 will also light up.
6. Using the group button, select (if necessary) the group to which you would like to
add the bulb while the feedback display still is blinking red/green.
The selected bulb will be assigned to default group (=group 1) if group button is
not pressed at all.
After approx. 10 seconds, the bulb will be added to the selected group
and the feedback display will stop blinking. Wait this long, not pressing any
buttons during this time.
The procedure will then end and you can use the extended group as normal.
Resetting the tint remote control
Resetting the remote control will delete all pre-defined group settings and you will
have to connect the tint remote control and the bulbs again afterwards.
1. Remove the battery compartment cover.
2. Use a pointed object or the battery compartment cover to press the reset button
on the back of the remote control.
3. Then, proceed as described in the section “Resetting the tint bulb” and then as
described in the section “Adding a new bulb”. Each bulb will then have to be
connected individually one after the other. If, for example, three bulbs belong to
one group, you must repeat the steps in “Adding a new bulb” 3 times.
Resetting the tint bulb
Resetting the tint bulb is only required in exceptional cases, such as when the remote
control has had to be reset.
1. Switch the tint bulb on and off 5 times
2. Switch the tint bulb on again. It will now begin to cycle through its colours. The
reset has occurred as desired and you can now use the tint bulb as normal using
your remote control or other Zigbee system.
Resetting the light colour
Resetting the light colour may be necessary if you have previously assigned the lights
to another function, such as the ‘Night light’ scene. The corresponding control unit is
inaccessible or the batteries might even be dead. You can set the light colour to warm
white very easily without completely resetting the bulb. This function can even be
used regularly if the tint remote control is not in arm’s reach at that moment.
