tint-BULB + MOBILE SWITCH
32
INSTRUCTION MANUAL
Wireless specifications
Frequency band of wireless RF mode: 2405-2480.0 MHz
Maximum transmission power:
<
20 mW
Radio range (free field):
30 m
Standby consumption per lamp:
<
0.5W
Mains voltage:
220-240V
Mains frequency:
50/60 Hz
Environmental conditions:
Temperature (operation):
-20 ° C ... 40 ° C
Temperature (storage):
-25 ° C ... 60 ° C
Relative humidity:
5-95% (no condensation)
Declaration of Conformity
Hereby Müller-Licht International GmbH declares that the radio equipment type
„Müller-Licht tint“ complies with the directive 2014/53 / EU.
The full text of the EU Declaration of Conformity is available at the following Internet
address:
www.mueller-licht.de/tint
Problem
Possible causes
You want to add a new bulb, but the ones
that are already added are blinking.
Switch off the bulbs that are already added
or remove them from the product that has
already been connected.
I cannot add a bulb to a new system
Please check whether the bulb is in
coupling mode.
I cannot add the bulb.
The bulb is already assigned to a remote
control or a gateway. Please remove it from
the existing network
Bring it closer to the remote control
Switch off any nearby Zigbee devices
I have to press the standby button several
times.
If the bulb has previously been switched off
using the light switch, the mobile switch
remote control will have to resynchronise.
You have switched off parts of the system
using a light switch. The mobile switch
remote control is resynchronising.
