Press the button and a beep will sound. The countdown will start.
Hold down the button to fast-forward by 30 seconds.
* The countdown can be set up to .
* If the alarm is not stopped for 2 minutes, countup timer starts
automatically.
If the clock does not function
properly, for example, because
of a display malfunction, remove
and then replace the battery.
Before using this product please read thoroughly the Precautions
regarding waterproofing . Using the product without strictly
following the contents laid down in these precautions may cause a
malfunction.
■
Regarding waterproofing
When the battery cover is securely attached, this product is
designed to have a waterproof level equivalent to the IP code IPX-4
(splash-resistant type).
* IPX-4 is the splash-proof protection standard.
It is confirmed that water does not penetrate the product in the
conditions assumed by usage in the vicinity of a shower with
water splashing from all directions for a period of 5 minutes.
* The waterproof function is designed to work for both fresh water
and tap water.
■
Important points regarding usage
Although this product is designed for usage in places where water
splashes, such as near a shower,
it is not completely waterproof
.
As malfunction may be caused, please pay careful attention to the
points below.
●
Do not put anything in the holes on the back of the speaker.
This can result in the loss of the waterproofing function.
●
Do not soak the product in or put any of the liquids listed in the
example below in on the product. Also do not put sand or mud
on the product.
Example liquids: soap, detergent, water containing bubble bath
or similar, seawater, swimming pool water, hot spring water,
boiling water, pharmaceutical products, etc.
●
Do not float the product on water or submerge it in water when
using. Also, do not intentionally splash water on it.
* It is possible to operate the buttons with hands wet with water.
●
If a lot of water is splashed on the product or if it falls into a
body of water, please wipe the water off immediately with a dry
cloth.
●
After using the product in a place such as a bathroom, wipe the
moisture off and place the product in a location with a low
moisture level.
●
Please do not use the product in locations with a high
temperature and humidity, such as saunas or bedrock baths.
●
When you are moving the product from a cold place to a warm
bathroom, for example, please move the product after it has
reached a normal temperature. If there are sudden changes in
the temperature, condensation is produced inside the product
and can cause malfunctioning as a result of problems such as
the development of rust and the shorting of the battery or circuit.
●
Please change the battery in a place with low humidity and with
hands wiped dry of water.
●
Please do not disassemble this product.
●
The waterproof effect of the waterproof packing gradually
declines. The progression of the deterioration varies depending
on the environment in which the product is used.
Good positioning
Bad positioning
(It is easy for water to penetrate the product)
Do not dip the product in water.
Do not touch with soapy hands.
Please do not insert anything
in the holes in the temperature
sensor or speaker.
This may cause a malfunction.
Press and release
forward
back
Press and hold
Fast forward
Fast rewind
⊕
⊖
⊕
⊖
Place the + of the (CR2032)
battery facing upwards.
blink.
To start setting the
calendar and time please
press the
⊕
or
⊖
button
as soon as the display
starts flashing.
January 1, 2011 12:00 a.m.
If it is difficult to remove the battery,
use a thin and insulated stick like a
toothpick by inserting it into this part
and take the battery out.
