MI.NODE - WATER Installation Manual
Rev 0.2
Mueller Systems – Confidential
Page 2
The electronic design utilizes the latest RF microchip technology which increases
reliability when compared to older RF designs
3. Installation
MI.NODE - WATER modules support two mounting options, either mounting to a ½” PVC
pipe for pit set installations or affixed to the side of a building. Pit set installations require
no drilled holes through the lid and are mounted beneath the polymer meter box lid for
security and ease of installation on PVC pipe. Surface mounts are easily accomplished with
the integral mounting brackets and two screws (not included).
3.1 Pit Set Installation
Please note that meters or registers should never be carried while supported only by
the AMR transmitter or wiring.
Tools Required: Length of ½” PVC pipe for pit depth, hammer
1.
PVC pipe should be cut to the proper length and installed deep
enough in the floor of each meter box that subsequent flooding will
not allow the stake and MI.NODE - WATER to change position. The
MI.NODE - WATER includes a ½” female PVC pipe fitting for easy pit
installation.
2.
For maximum radio performance, once installed, the top of the
transmitter should be located approximately ½” inch below the pit
lid in the center of the meter box to maximize RF performance.
3.
Once the PVC stake is installed, the MI.NODE - WATER should be
pushed down onto the stake by hand until the interference fit
engages securely, two solid stops are molded into the PVC
Installation Slot in order to prevent the wire from being pinched
when installed.
Never hammer MI.NODE - WATER onto the stake since this may result in damage
to the electronic components inside the unit.
3.2 Exterior Wall Mounting
Please note that meters or registers should never be carried while
supported only by the AMR transmitter or wiring.
Tools Required: 1 – 1 1/2 inch Galvanized, or Stainless Wood or Sheet Metal
Screws (2 per), Phillips Screwdriver
1.
The open ended wire from the device permits routing through interior
walls for external wall mounting when required or direct mounting to
exposed floor joists above grade level.
2.
Mi.Node - Water can be directly mounted to almost any flat surface by
using the holes shown and common screws in most instances.
½” PVC
Mounting Holes
