HINTS FOR SAFE OPERATION
DO
Study this manual before operating your
Power Barrow 4WD.
DO
Check all nuts, bolts and wheel studs weekly.
DO
Be safety conscious and dress appropriately when operating your
Power Barrow 4WD.
Always wear substantial footwear and a hard hat in relevant areas.
DO
Exercise extreme caution with the controls when working on steep or slippery surfaces.
Especially, when people are near to the working area.
DO
Ensure that all safety guards are in place when operating the
Power Barrow 4WD.
ATTENTION
DO
Keep the
Power Barrow 4WD
free of any accumulation of dirt, grease, oil or other
flammable material.
DO
After use, connect the truck to the supplied battery charger. The battery
charger should be left powered up and connected to the
Power Barrow 4WD
until the
Power Barrow 4WD
is next used. This will ensure that the batteries are fully charged when
the
Power Barrow 4WD
is next to be used.
Note that there is no inhibit on the drive motor whilst the battery charger is
plugged into the
Power Barrow 4WD
socket.
BE SAFE: FOLLOW INSTRUCTIONS AT ALL TIMES.
DO NOT
Allow anyone lacking in experience to operate your
Power Barrow 4WD
.
DO NOT
Carry
“
passengers
”
on your
Power Barrow 4WD
.
DO NOT
Start work without completing the daily maintenance checks.
DO NOT
Operate the
Power Barrow 4WD
without exercising appropriate safety precautions.
DO NOT
Use other types of battery charger or batteries.
HINTS FOR SAFE OPERATION
ATTENTION
DO NOT
Pressure wash directly onto the trucks electronics.
BE SAFE:
EXERCISE COMMON SENSE AT ALL TIMES.
OPERATING INSTRUCTIONS:
GETTING STARTED:
1.
Plug your charger cable into the mains and your machine for a minimum of 4 hours.
TO MOVE FORWARD:
1.
Switch the on/off button to ON. The switch will illuminate.
2.
Select
“
FORWARD
”
on the rocker switch on the Top Controls.
3.
Grip the handlebars and pull up on the left hand lever. The parking brake will
be automatically released and the
Power Barrow 4WD
will start to move. The more the
lever is raised, the faster the
Power Barrow 4WD
will move.
TO REVERSE:
1.
Release the left hand throttle lever to stop the
Power Barrow 4WD
.
2.
Move the rocker switch to
“
REVERSE
”.
3.
Grip the handlebars and pull up on the left hand lever. The more the lever is
raised, the faster the
Power Barrow 4WD
will move.
TO STOP:
Release the throttle lever. The
Power Barrow 4WD
will slow down and stop. The parking brake will
automatically come on.
After 10 minutes of inactivity, the controller will power down. The on/off
switch must be pushed to off and back on again to activate the
Power Barrow 4WD
.
TO EMPTY THE SKIP
To empty the skip, press the EMPTY rocker switch on the Top Controls, then push the button on the right
handlebar.
TO RETURN THE SKIP
To return the skip, press RETURN rocker switch on the Top Controls, then press the button on the
right handlebar.