Muchmore CTX-W platinum Operation Manual Download Page 7

7.Lap timer

E5

4.Lap timer
1.Quick warm

Check your competitor's lap time at the table! (up to 99Laps), Quick warming or CTX warming can not be operated simultaneously in this mode.
Only Minimum temp function will act.

Determine race minutes

or     :

How to check lap times

READY      00:00.00
LAP --       

START(or STOP)

 00:00.00

Race time set

08minutes

RUN          00:01.35
LAP --        00:00.00

RUN          00:13.35
LAP 01      00:13.35

FINISH LAP

LAP COUNT

Time goes up

1lap counted

2lap counted

Final lap counted.

Recall data

RECORD CALL

+2seconds : Data clear

RECORD CALL

1.

2.

RUN          00:26.55
LAP 02      00:13.20

LAP COUNT

3.

READY      00:40.05
LAP 03  

 00:13.10

4.

READY      00:40.05
LAP 03  

 00:13.10

5.

WARNING

Do not leave the CTX-W unattended. Do not connect 12V power supply 
directly to the battery charge input.When you insert your battery pack into the 
CTX-W, make sure the batteries polarity and direction are correct. Wrong 
connection may cause unit to fail. The remote possibility of a failure could 
cause a short circuit by improper connection. This could cause the battery to 
rupture. If cells are too hot to touch there is something wrong and the pack 
must be disconnected from the CTX-W. Muchmore Racing(or their 
associated distributors) shall not be liable for any property damage or 
personal injury which may result from the failure to follow these instructions 
or other improper use of this product. Avoid any contact of your CTX-W with 
water or other liquids. Never operate on carpets, cloths, pit towel or other 
materials. Disconnect the CTX-W from power supply when not in use. Only  
insert serially switched battery packs. Never connect the CTX-W directly to a 
110/230 VAC power source. For best performance, we recommend the 
Power Master(24A power supply #MM-CTXP3). New warmers may produce 
a slight odour in the first few hours of service due to materials curing inside 
the device.

Product Warranty

MUCHMORE RACING warrants their CTX-W to be free from defects in material and workmanship 
for a period of 120 days from the date of purchase.  This warranty applies only to the original 
purchaser.  MUCHMORE RACING (or their associated distributors) will repair or replace without 
charge, or refund the purchase price of any product which fails during the warranty period by reason 
of defect in material or workmanship found upon examination by MUCHMORE RACING to have 
been the cause of failure. This warranty does not cover any failures attributable to abuse, 
mishandling, failure to follow operating instruction, alteration or accident.  To make a claim under this 
warranty, the purchaser must return the product to MUCHMORE RACING (or the relevant Countries 
associated distributors) at the address shown E6(last page), properly packed and with shipping 
charges prepaid. All claims must be made within thirty (30) days from the product failure and, in any 
event, within thirty (30) days of the expiration of the 120 day warranty.  All claims must be 
accompanied by a sales slip or other written proof of date of purchase.  The maximum repair costs 
for any failure caused by the purchaser are 50% of retail price (original purchase price).  Since we 
cannot supervise the proper use of our products, we can not accept any liability for direct or indirect 
damage of any type arising from their use or occurring to the property of the user and/or third parties. 
Therefore, any use of this product shall take place at the user's own risk. The warranty claim may not 
exceed the value of this product in any case. By putting this product into operation you accept the 
above conditions and assume full responsibility for use of this product.

 

Summary of Contents for CTX-W platinum

















Reviews: