• Setting For Components and Separates: First enable the electronic crossover by selecting the “ON”
position of the X-OVER switch, then select the “H-PASS” (High pass) position on the L-PASS/H-PASS switch.
By selecting this you are giving the speakers 85Hz – 20kHz. The 12dB/Oct roll off means that the frequencies
under (lower then) the set 85Hz, will taper off at moderate slope.
• Setting For Full Range (No Crossover): To disable the electronic crossover, select the “OFF” position of the
X-OVER switch. This setting will allow the amplifier to play all frequencies.
4. Remote Subwoofer Level Control (Remote Sub) – Lets say the amplifiers gain is set at half way, when the
remote subwoofer level control is plugged in, you now have external control of the gain from zero – half way.
The installation of this level control is NOT necessary to get full power from amplifier.
5. Prizm EFX – Now that you have completed adjusting all your amplifier settings, you can set the lighting effects
to you personal taste.
• Selecting Colors: You can change the backlit colors simply by turning the Pot labeled PRIZM COLOR
located in the MTX PRIZM EFX section of the control panel left or right. Starting at the most counter clockwise
position, the colors range from RED, GREEN, BLUE, and RED again or any color in between making the
combination unlimited.
• Selecting The EFX Feature: You can switch Prizm EFX lighting to “pulsate” with beat of music. Simply
depress the button labeled PRIZM EFX located in the in the MTX PRIZM EFX section of the control panel to
turn this feature on or off.
Troub le Shooting
Read this if you want to be a do-it-yourselfer or give us a call at 800-CALLMTX.
PROBLEM
CAUSE
SOLUTION
No LED indication
No +12V at remote connection
12V to terminal
No +12V at Power connection
12V to terminal
Insufficient ground connection
Verify ground connection
Blown power fuse
Replace fuse
LED on, no output
Volume on head unit off
Increase volume on head unit
Speaker connections not made
Make speaker connections
Gain control on amplifier off
Turn up gain
Signal processing units off
Apply power to signal processor
All speakers blown
Replace speakers
Output distorted
Head unit volume set too high
Lower head unit volume
Amplifier gain set too high
Lower amplifier gain
Balance reversed
Speakers wired L + R reversed
Wire speakers with correct orientation
RCA inputs reversed
Reverse RCA input
Bass is weak
Speakers wired out
Wire with correct of phase
phase
Not using MTX woofers
Buy MTX woofers
Blowing fuses
Excessive output levels
Lower volume
Amplifier defective
Return for service
