4.
Using furnished wiring harness route 10ga red power wire starting
at pre-amp location. Route wire under rear seat on driver's side, over to
threshold and under carpet to the front of vehicle.
5.
Open hood.
6.
Drill a hole through the firewall. Locate a spot low on the firewall on the
driver’s side. You should always look to find a clear path. Drill a hole from
inside of the vehicle into engine compartment and insert grommet.
Firewall
Battery
Drill Hole
for Grommet
Note: To avoid any damage to parts inside engine compartment,
drill from inside of vehicle using a short bit.
7.
Route 10ga red power wire through grommet into the engine compart-
ment.
8.
Route 10ga red power wire through engine compartment safely away
from any moving or hot parts that could damage the wire.
9.
Cut 10ga red power wire to length, connect the supplied fuse holder
from the wire kit to the end of the wire.
Optional
- The EBC, or Electronic Bass Control, allows a remote bass
control to be adjusted from the driver's seat.
Setting Crossover
You should set the crossover to your own personal listening taste. The
crossover is adjustable to any frequency between 50Hz (counterclock-
wise) to 150Hz (clockwise). As a guideline, the goal is to create the illu-
sion of bass up front. The higher the crossover point the more “audibly
visible” your sub is going to be. Take your time and really listen to your
system, grab a soda and a few of your favorite tunes and have fun.
TROUBLESHOOTING TIPS IF AMP DOES NOT TURN ON
Check all connections at battery and that fuse is installed
Check speaker wire connections
Check ground
Check fuse on pre-amp
18.
Reinstall threshold trim. Locate and align holes in vehicle with pins
on trim; secure with the three phillips head screws removed earlier.
19.
Using hardware provided, attach the mounting brackets to the enclo-
sure as shown below. If installing in a 1999 or newer model, add rubber
foot as shown below.
1999 or Newer
20.
Using screws provided, install the enclosure into vehicle as shown
below.
2
5
