10
Premier Climax Logger Steam Engine
Maintenance:
Lubrication and Greasing Instructions
The engine should be oiled and greased in order to run properly.
You should regularly lubricate all side rods, linkage components, gears and
pickup rollers to prevent them from squeaking. Use light household oil and
follow the lubrication points marked “L” in Fig. 2. Do not over oil. Use only
a drop or two on each pivot point.
The locomotive’s internal gearing was greased at the factory and should not
need additional grease until after 50 hours of operation or one year, whichever
comes first. To access the gear box, do the following:
1. Remove the boiler shell.
2. Remove the Phillips screws located on the front of the motor mounting
plate.
3. Use a grease tube dispenser to put a small amount (approx. 1-2 ml.) of
lithium-based grease into the gearbox.
4. Replace the screws and reassemble the engine.
You should also grease the trailing locomotive truck tongue to enhance their
ability to slide on the chassis. Follow the grease points shown on Fig. 3.
Lubricate Pick Up Rollers (L)
Lubricate Side Rods (L)
Figure 2. Lubrication Points on the Engine
Body Mount Screws
Grease Bronze Drive Gear (G)
Body Mount Screws
Figure 3. Greasing Points on the Engine and Body Mounting Screws
