MTI LOCKS
™
PRODUCT MANUAL
4
MTI P/N 063-00168 rev D ©2017 MTI All Rights Reserved
MTI
1050 NE 67th Avenue Hillsboro, OR 97124 T:800.426.6844 www.mobiletechinc.com
2
2
CAUTIONS
RFID PROGRAMMING
Entering Registration Mode (Initial Setup)
1. Swipe Authorization Card on the Lock (this will be the Authorization Card’s ID in the lock’s memory). The lock will emit 2 double beeps, indicating the
lock is ready to receive User Keys.
2. Each lock will stay in registration mode until it is closed with a swipe of the Authorization Card (emitting 2 quadruple beeps to indicate a closed session)
or is left idle for 3 minutes.
Registering User Keys to Each Lock
1. Individually swipe each User Key (up to 251) over the lock until all User Keys have been entered into the lock’s whitelist.
a. After each User Key swipe, the lock will emit a 2 beep ascending tone to confirm the key has been added.
b. Should a User Key add error occur, the lock will emit 4 fast beeps to indicate a key add error.
2. Swipe Authorization Card to close the registration session.
Deleting User Keys Whitelist on Locks
1. Place Authorization Card on the lock for 5 seconds until it emits a slow ticking signal.
2. Remove Authorization Card (ticking will continue).
3. Swipe the Authorization Card on the lock during this period to delete the entire whitelist of User Keys.
a. Lock will delete the whitelist and then emit an ascending 2 beep tone, indicating success.
b. Should a User Key delete error occur, the lock should emit 4 fast beeps to indicate a key delete error.
c. Note: Authorization Card’s information is not deleted.
Reset Locks to Default Mode
1. Remove lock from installed position
2. Press and hold the button on the back of the lock until it emits a 2 beep ascending tone (~3 seconds).
3. After tone is heard, release button
4. Lock will be reset
a. This deletes all User Keys, including the Authorization Card
.
Correct Disposal of Product
This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To dispose of used
devices contact MTI Global Services Contact Center at
503-648-6500 or contact local recycling company for proper
recycling instructions for electronic devices.
Battery Caution
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications
could void the user’s authority to operate the equipment.
The RF Exposure Compliance distance is 20 millimeters.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
