I
NSTRUCTIONS
To replace the interior lights, follow these steps: Remove the recessed mounting screws located under the specific car you are
servicing, as shown in Fig. A-C. Pop the roof off the car by holding each end of the car and twisting them in the opposite
direction. Tilt the plastic housing for the bulb(s) you want to change so you can reach the light bulb, then pull the bulb gently
from its socket, like a Christmas tree light. Replace the bulb and reassemble in reverse order. You can obtain replacement bulbs
directly from the M.T.H. Parts Department (phone: 410-381-2580; e-mail: [email protected]; mail: 7020 Columbia
Gateway Drive, Columbia MD 21046-1532)
STEP
1
1
STEP
2
2
Baggage Car (8 screws)
Coach, Dome Car, Sleeper, Diner (2 screws)
Observation Car (3 screws)
STEP
3
3
STEP
1
STEP
2
STEP
3
Figure A, B, C
A
B
C
D
E
F
This set is delivered without a coupler
on the back of the observation car.
Should you choose to add the spare
coupler included with the set, follow
the instructions below.
• Complete steps 1 and 2 above to
remove the roof from the observation
car
• Remove the truck mounting screw
from inside the car as shown in Figure
D and pull the truck loose from the
body.
• Install the coupler spring as shown
in Figure E.
• Screw the coupler onto the truck.
As shown in Figure F.
• Reassemble in reverse order.
Truck
Mounting
Screw
I
NSTRUCTIONS
To replace the interior lights, follow these steps: Remove the recessed mounting screws located under the specific car you are
servicing, as shown in Fig. A-C. Pop the roof off the car by holding each end of the car and twisting them in the opposite
direction. Tilt the plastic housing for the bulb(s) you want to change so you can reach the light bulb, then pull the bulb gently
from its socket, like a Christmas tree light. Replace the bulb and reassemble in reverse order. You can obtain replacement bulbs
directly from the M.T.H. Parts Department (phone: 410-381-2580; e-mail: [email protected]; mail: 7020 Columbia
Gateway Drive, Columbia MD 21046-1532)
STEP
1
1
STEP
2
2
Baggage Car (8 screws)
Coach, Dome Car, Sleeper, Diner (2 screws)
Observation Car (3 screws)
STEP
3
3
STEP
1
STEP
2
STEP
3
Figure A, B, C
A
B
C
D
E
F
This set is delivered without a coupler
on the back of the observation car.
Should you choose to add the spare
coupler included with the set, follow
the instructions below.
• Complete steps 1 and 2 above to
remove the roof from the observation
car
• Remove the truck mounting screw
from inside the car as shown in Figure
D and pull the truck loose from the
body.
• Install the coupler spring as shown
in Figure E.
• Screw the coupler onto the truck.
As shown in Figure F.
• Reassemble in reverse order.
Truck
Mounting
Screw