7
6.
Align the holes in the rear of the lift arms with the holes in the rear of the undercarriage assembly and reinsert
the clevis pins removed in step 2 through both sets of holes. Fasten with the hairpin clips removed in step 2.
7.
Move the tractor’s deck lift lever into the top notch on the right fender allowing the lift arms and the rear of the
undercarriage assembly to rise.
8.
Insert the weldpins found on the top side of the rear portion of the undercarriage assembly up through the
aligning holes found along the tractor’s frame. Fasten with the hairpin clips and flat washers removed in step 1.
Refer to Figure 4.
9.
Repeat the previous step on the front portion of the undercarriage assembly.
Attaching the Chute Directional Control
Figure 5
1.
Attach the chute directional control assembly to the upper lift link on the left side of the auger housing assembly
with two hex screws and two flange lock nuts as illustrated in Figure 5.
2.
Slide the upper chute crank rod through the eyelet in the top of the chute directional control, the eyebolt found
midway down and into the joint block found on the lower chute crank rod. See Figure 5.
3.
Affix the upper chute crank rod to the joint block on the lower chute crank rod with the cotter pin provided. See
Figure 5.
4.
Fasten the chute tilt cables to the chute directional control with two of the four cable ties provided. Pull the cable
ties until they’re snug and trim off any excess.
Upper Chute Crank Rod
Lower Chute Crank Rod
Eyebolt
Cotter Pin
Hex Screws
Joint Block
Chute Directional Control
Upper Lift Link
Eyelet
Cable Ties
Auger Housing
Support Bar
Auger Housing Support Bar
