MTD E740, Operator'S Manual

Page: 17 / 28

17
SECTION 11: OFF-SEASON STORAGE
WARNING:
Never store engine with
fuel in tank indoors or in poorly
ventilated areas, where fuel fumes may
reach an open flame, spark or pilot
light as on a furnace, water heater,
clothes dryer or other gas appliance.
If unit is to be stored over 30 days, prepare for
storage as follows:
1.
Remove all gasoline from carburetor and fuel
tank to prevent gum deposits from forming on
these parts and causing possible malfunction of
engine.
a. Run engine until fuel tank is empty and
engine stops due to lack of fuel.
b. Drain carburetor by pressing upward on bowl
drain, located below the carburetor cover.
WARNING:
Drain fuel into approved container
outdoors, away from open flame. Be certain
engine is cool. Do not smoke. Fuel left in engine
during warm weather deteriorates and will cause
serious starting problems.
NOTE: Fuel stabilizer (such as STA-BIL) is an
acceptable alternative in minimizing the formation of
fuel gum deposits during storage. Add stabilizer to
gasoline in fuel tank or storage container. Always
follow mix ratio found on stabilizer container. Run
engine at least 10 minutes after adding stabilizer to
allow it to reach carburetor. Do not drain carburetor
if using fuel stabilizer.
2. Remove spark plug and pour one (1) ounce of
engine oil through spark plug hole into cylinder.
Crank engine several times to distribute oil.
Replace spark plug.
3. Remove all dirt from exterior of engine and
equipment.
4. Follow lubrication recommendations on page 14.
5. Store in a clean, dry area.
NOTE:
When storing any type of power equipment
in an unventilated or metal storage shed, care
should be taken to rust proof the equipment. Using
a light oil or silicone, coat the equipment, especially
any chains, springs, bearings and cables.