12
S
ection
4 — A
SSembly
& i
nStAllAtion
Figure 4-18
Note:
On decks without deck wheels, hook the retainer
strap into the hole provided in the flange on the front-side
of the cutting deck. See Figure 4-19.
1
2
3
Figure 4-19
Note:
When assembling this bagging unit on an older
deck, an extra wing knob, which is only needed on
installations on new decks, will be left over.
IMPORTANT:
Be certain that the bottom of the discharge
chute is positioned inside of the lip of the deck opening, as
shown in Figure 4-16.
Tractors With Older Deck Configurations
1.
Install one of the rubber chute straps onto the chute
elbow using one of the supplied clevis pins (711-05063),
washer (736-0204) and Bow-tie cotter pins (714-04040) from
hardware pack 689-00318A. See Figure 4-17. Secure the end
of the strap utilizing the hole furthest from the end, insert the
smaller hook end of the torsion spring hook (732-04510A) into
the other end.
Note:
On decks with front deck wheels, the boot mount
rod must be removed in order to install this discharge chute
elbow onto the tractor. See Figure 4-17.
Remove the Boot Mounting Rod
Figure 4-17
2.
Install the deck mounting pin (711-05049) up into the chute
elbow using two flat washers (936-0176) from hardware pack
689-00318A and secure with a flange lock nut (912-3027), as
shown in Figure 4-17.
3.
Remove the boot mounting rod and hardware at indicated
in Figure 4-17.
4.
With the tractor’s discharge chute raised up and held open,
install the chute elbow over the chute opening by placing
the deck mounting pin in the hole provided, as shown in
the upper inset of Figure 4-19, then secure the elbow to the
deck by hooking the retainer strap torsion spring hook over
the deck wheel mounting bracket as shown in Figure 4-18.
Summary of Contents for 19C70020OEM
Page 16: ...Notes 16...
Page 17: ...17 Notes...
