Advisory MTD-148
2 of 2
SERVICE MANAGER
PARTS MANAGER
SALES MANAGER
SERVICE TECH.
SERVICE TECH.
Circulate and Initial
Warranty:
Normal warranty terms apply. Indicate Service Advisory
MTD-148
and
P/N
625-04105
as the original failed
part on the claim. Repair time allowance is
0.15
Hrs.
List model and serial number of the unit on the claim.
GROUP CODE:
ELECTRICAL
FAIL CODE:
FACTORY REWORK
WORK PERFORMED:
HEADLIGHT SOCKET / BULB / HARNESS TROUBLESHOOT
Mandatory>>>
When completing the warranty claim, select the drop down text shown below for the following claim fields:
ITEM
NO.
PART
NUMBER
QTY
DESCRIPTION
1
725-05239
2
Headlight Assembly - LED
2
777I25154
1
Label
*
1
THIS INSTRUCTION SHEET
NOTE:
Save this Instruction Sheet. Refer to it when ordering replacement parts.
Service Kit Contents
*
- Not Available Separately
Pre-Service Preparation:
1. Park mower on a flat, level surface.
2. Turn off the engine, remove the ignition key, set the parking brake to ON.
3. Allow engine and muffler to cool before proceding.
4. Verify that battery is fully charged, then proceed to
Service Procedure.
Service Procedure:
1. Raise hood and locate the left and right headlight assemblies located in the grille.
2. Unplug mower wire harness from each headlight assembly. (725-1649 Lamp Socket and 725-0963, Lamp Figure 1)
3. Twist headlight assembly counter-clockwise approximately 1/4 turn, remove and discard headlight assemblies.
4. Align tabs on LED Headlight assembly with mounting holes, twist LED Headlight clockwise until it locks in place.
5. Plug large connector from LED Headlight harness into large connector on mower wire harness.
6. Plug small connector from LED Headlight harness into small connector on mower wire harness.
7. Start engine and verify operation of LED Headlights.
8. Apply label 777I25154 to the left leg of headlight harness as shown in Figure 2.
725-05239
LED Headlight Assembly
725-1649 Lamp Socket
725-0963 Lamp
FIGURE 1
Add Photo of applied label
FIGURE 2