Assembly & Set-Up
3
7
Contents of Carton
•
One Snow Thrower
•
One 20 oz. Bottle 5W-30 Oil
•
Two Ignition Keys
•
One Chute Assembly
•
One Snow Thrower Operator’s Manual •
One Engine Operator’s Manual
NOTE:
This Operator’s Manual covers several models. Snow
thrower features may vary by model. Not all features in this
manual are applicable to all snow thrower models and the snow
thrower depicted may differ from yours.
NOTE:
All references to the left or right side of the snow thrower
are from the operator’s position. Any exceptions will be noted.
Assembly
Positioning the Upper Handle
1.
Remove the wing knob and carriage bolt from the top of
the lower handle. See Fig. 3-1. It is not necessary to remove
the shoulder screw and flange lock nut below the wing
knob and carriage bolt.
2.
Pivot the upper handle into the operating position. Be sure
not to pinch any of the cables in the process. See Fig. 3-2.
3.
Tighten the previously removed hardware to secure the
handle in place. See. Fig. 3-2.
Installing the Chute
1.
Place the chute handle on the lower chute as shown in Fig.
3-3. Be certain that the handle is aligned in the channel on
the chute and the tabs snap into place.
Wing Knob
Wing Knob
Carriage Bolts
Figure 3-1
Figure 3-2
Channel
Tab
Figure 3-3
Summary of Contents for 31AS2T5E504
Page 18: ...18 Notes...
Page 19: ...Notes 19...
