•
Insert the screws (J) through all of these holes from the top, and tighten
them firmly from the bottom with nuts (C), so that some of the screws also
hold the handle on each side of the unit.
•
This way, the device is ready for use, i.e. the entire heating unit is
permanently connected to the frame base and the transport handle.
•
Finally, mount the end of the exhaust outlet on the top.
3.3.
Working with the device
3.3.1
Refueling
IMPORTANT: Use only diesel fuel or heating kerosene to power the
unit.
The fuel should be fresh and free from contamination - it is not
recommended to store fuel in an unused device for more than 1-2
months.
For refueling, use a special funnel (not included in the set), which will
help in preventing fuel spilling on and around the device.
Before refueling, the device should be turned off, disconnected from
the power supply and cooled down to minimize the risk of ignition.
•
Place the device on a stable, flat and even surface.
•
Unscrew the fuel cap - do not remove the mesh filter (it protects
against dirt accidentally entering the fuel system)!
•
Insert a special funnel into the opening.
