© MSR Electronics GmbH, 2022-02-22. All rights reserved.
8
MSR Electronics GmbH • Mettlenstrasse 6 • CH-8472 Seuzach • Switzerland
Phone. +41 52 316 25 55 • [email protected] • www.msr.ch • www.datalogger.shop
START Data Loggers MSR83, MSR84, MSR86
Check the status of the data logger: During recording [RUN] & Stop [STOP] mode, press the START button once to view MIN | MAX | AVERAGE values.
Display Indication:
LCD Indication
Only Current Reading
START
RUN
STOP
OK
NOT OK
Lo VOLT
Data Logger Status
not started
waiting to START recording (in delay start mode)
started recording
recording is stopped
no alarm conditions
LO | HI alarm condition
low battery
START the data logger:
Initially, the current reading will be shown on the display before starting the data logger. Keep the START button pressed continuously for 5 seconds to start
the logger. The green LED and the red LED will start flickering confirming the logger has been started successfully. The display will indicate START until the
delay start time is over. After completion of the delay start time, the display will indicate RUN and the current reading confirming logger has been started
successfully.
Note: Do not use the data logger if START is not shown on the display or if the LED is not ON after pressing the START button for 5 seconds.
«Lo VOLT» on the display indicates low battery. Avoid using logger without battery replacement.
LED
I
NDICATION
T
AMPERPROOF
&
R
OBUST
C
ASE
2.0
A-T
YPE
USB
C
ONNECTION
