9
POWER PACK OPERATION
Warning: to avoid function failure and damage, please do not operate until spa is filled with water to the
minimum water mark.
It is the owner’s responsibility to make sure the installation conditions are met and the following safety and warning
rules are exercised. Any failure and damage which result from dry-run, water spillage, excessive humidity, or
structural loading will void the warranty.
Control Panel Instruction:
LED Display: Once switched on, the LED panel displays the current water temperature automatically.
“ON/OFF” Button:
To activate power pack.
“C/F”Button:
To select temperature display
(Celsius / Fahrenheit).
1. “BUBBLE” Button:
To activate Bubbling function.
The bubbling system has a 20-minute operation
auto shut down for 10-minutes feature.
The light of Bubble button is on when being activated.
Note:
If the Bubble function works for over 15 mins and is
stopped manually, you will need to wait for 10 minutes to activate the Bubble function again.
2. “FILTER” Button:
To activate Filtration system. The light of “FILTER” button displays green when the
filtration system is activated.
3. “HEATER” Button:
To activate Heating and Filtration system at the same time.
(Filtration system cannot be turned off when heating)
4. “TEMPERATURE” Button:
To set and display water temperature
5. “UP” Button:
Increase temperature
6. “DOWN” Button:
Lower temperatrure
NOTE:
The set temperature defaults to 38°C (100°F) when first plugged in.
NOTE:
Temperature can be adjusted between 20°C (68°F) and 42°C (108°F).
The control panel displays set temperature when press “TEMPERATURE” button once, and then displays current
water temperature after 1 second.
When pressing “TEMPERATURE” for 3 seconds, LED starts to flash and then you can set your desired temperature
by pressing up “ ” and down “ ” buttons. After temperature is set, you may press the temperature button again or
leave it for 10 seconds and then it’ll display current water temperature.
NOTE:
In case when leaving spa under unattended working condition, you can press up “ ” &. down “ ” buttons
at the same time to lock the control panel to avoid any wrong operation by children. To unlock, press both
buttons at same time again and after “D” sound, it unlocks automatically.
The light of the “HEATER” button displays red when the heating system is activated.
NOTE:
It’s normal that filtration system cannot be turned off individually when it is working.
NOTE:
Filtration function can only be turned off by pressing “HEATER” button but not “FILTER” button.
The heater will be stopping heating until the current water temperature reaches the set temperature. After the set
temperature is reached, the “FILTER” button will be off and “HEATER” button shows green. After the current water
temperature drops 1°C below the set temperature, the heating system will restart and light turns into red. The “FILTER”
button will be activated automatically at the same time. The heat increase rate is maximally 1.2 to 2.5°C(1-3°F) per
hour.
Please note that the following conditions will lead to slow heating without heating phenomenon:
1. Environmental temperature lower than 10°C(50°F)
2. Outdoor wind force above Gentle breeze/F 3
3. Environmental temperature lower than 10°C(50°F) and wind power above Gentle breeze/F 3
4. Activate bubbling system when heating
5. Spa lid is not covered or improperly covered when heating
It is recommended to fill spa tub with luke warm water for quick heating and energy saving.
ON /
OFF
ºC
ºF
Summary of Contents for B- 131 Luxury Exotic
Page 13: ...13...
