7
REF. NO.
PARTS DESCRIPTION
QTY.
PART NO.
Spa cover with aluminum foil inside
(Alpine B-091* comes with a ground mat with the cover)
Control panel with air pipe
Heat preservation bubble mat (For B-100/110/112/120/121/141/130/150)
Heat preservation foam mat (For B-131/151/132/152)
Digital lock (except for Alpine B-091*)
Inflation hose
Manometer
Filter cartridge set
Spa drain valve adaptor
Wrench
Wicker side bar (Only for Nest B-100*)
Instruction DVD
Check the part No. with MSpa Service
Center by providing the model No.
B9300497(control panel)
B9300312(air pipe)
Check the part No. with MSpa Service
Center by providing the model No.
B9300109N
B9300492N
B9300672
B9300671
B9300637
B0301964
B9300670
Check the part No. with MSpa Service
Center by providing the model No.
B0301969-for 4-person round spa
B0301970-for 6-person round spa
B0301971- for B-100*
B0302010- for B-091*
B9300419
N/A
Buckle spa cover B9300639
Ground mat set B9300707
N/A
FIRST USE AND SET-UP PREPARATION
The spa can be installed indoor and outdoor. For household use only.
The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the maximum load of the filled spa
with listed maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can damage the spa and void
your warranty. Level the surface before filling spa with water.
Provide adequate drainage system around the spa to deal with overflow water and splashes.
Provide a properly located power outlet to connect the spa and allow easy access for period testing of the cord mounted RCD/GFCI.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance and/or service.
NOTE:
When ordering parts, be sure to quote the model number and part numbers.
Site preparation and requirements
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check with a qualified contractor
or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of any other material that could
damaged by the moisture.
Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow moisture to escape. Install
a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for indoor installation
K
Repair kit
C
D
E
F
G
H
I
J
A
B
Spa tub
L
Spa cover inflatable bladder
O
P
M
N
Buckle spa cover and ground mat set
1
1
1
1
1
1
1
1
1
1
1
1
1
2
1
