2-13
Hardware Setup
.
IDE1
(Primary IDE Connector)
IDE1 can connect a Master and a Slave drive. You must configure the second hard
drive to Slave mode by setting the jumper accordingly.
Hard Disk Connector: IDE1
The mainboard provides a one-channel Ultra ATA 133 bus Master IDE controller
that supports PIO mode 0 ~ 4, Bus Master, and Ultra DMA 66/100/133 function. You can
connect up to two hard disk drives, CD-ROM drives, 120MB floppy disk drive (reserved
for future BIOS), and other devices.
IDE1
Connectors
Important
If you install two hard disks on cable, you must configure the second drive to
Slave mode by setting its jumper. Refer to the hard disk documentation sup-
plied by hard disk vendors for jumper setting instructions.
Front USB Connector: USBT2
The mainboard provides one standard USB 2.0 pin header to connect to the fornt
MCE IR for remote control.
USBT2
GND
USB+ USB-
USBVCC
