2. Using supplied bolts, attach
included AC-LA8-BACK back
plate to rear of speaker.
WARNING: Do not exceed
100 in-lbs when installing bolts
in threaded inserts.
3. Set LA880it on top of
LA808i and attach supplied
AC-LA8-LINK-II side plates using
supplied bolts.
4.
Attach supplied
AC-LA8-LINK-II back plate
using supplied bolts.
5. Attach included safety
cables to each bent bracket
(on LA808i-II and LA880i-II),
and secure to the structure
using installer supplied
fasteners.
6. Choose one of two inputs:
SpeakOn ,
™ or included
Euroblock. Note: Signal wire
must connect to LA808i-II.
Do not connect signal wire
directly to LA880i-II.
7. If using Euroblock input,
connect signal wire to
four-pin Euroblock plug. If
using SpeakOn™ connector
skip to step 10.
8. Insert wired 4-pin Euroblock
jack into speaker. Connectors
are keyed for polarity. Skip to
step 11.
10. If using SpeakOn™ cable,
insert the end of the cable into
the SpeakOn™ input
connector, and twist to lock.
10. Connect included jumper
cable from LA808i-II output to
LA880i-II SpeakOn™ input.
Jumper cable passes the
proper signal from LA808i-II
to LA880i-II for maximum
performance.
11. Flip LFDE switch on
LA880i-II to "YES". Failure to
flip the switch will negatively
impact sound quality.
12. Done!
1.435.64 7.9555
|
800.64 7.TUBE
|
www.soundtube.com
LFDE Integration Instructions
NOTE: To further constrain the low frequency beamwidth, two LA808i-II LFDE units may be used. In this case mount one LA880i
-II
between the two
LA808i
-II
units. Wire one LA808i
-II
and the LA880i
-II
as described above. Feed the other LA808i
-II
the same full range signal, but from another amplifier
channel. Do not wire the two units in parallel unless the amp is 2 ohm stable.
1. Unpack speaker.
