STEP 3
There are three Euroblock connector terminals on the rear of the speaker
cabinet. The terminals are marked for Right Input, Center Input and Left
Input and should be connected to the respective speaker channel outputs
on your receiver. Connect the speaker wires to the correct terminals
observing the polarity indicated on the Euroblock connector. Strip about
.25” of insulation from the wires and separate the wires as necessary.
Connect the signal wires to the 2-pin Euroblock connectors ((+) indicates
positive and (-) indicates negative)
(Figure 5)
. Make sure the connections
are tight. Tuck the speaker wires behind the Soundbar cabinet, using tie
wraps if necessary to secure wires.
4
See step 3 for more detailed information on wiring the TSB3.0. Gently
slide the Mounting Pins into the vertical mounting slots on the Mounting
Brackets. Removal of the flat panel display may be necessary before
mounting the TSB3.0. The Leveling Screws may be inserted in the bottom
of the Mounting Bracket and used to adjust the height and to make sure
the TSB3.0 speaker is level. Tightening the screw will raise the speaker and
loosening it will lower it.
STEP 2.2 – TABLE TOP MOUNTING
Place your TSB3.0 speaker face down on a soft clean surface with the
grille on. Orient the speaker so the input terminals are on the right hand
side. To attach the Table Top Mounting Feet to the Mounting Brackets, first
remove the Leveling Screws from the underside of the Mounting Brackets
and attach the Table Top Mounting Feet to the bottom of the bracket using
the two supplied Phillips Table Top Mounting Feet Screws. Make sure that
you orient the feet so that the longer side points to the front of the TSB3.0
(Figure 4)
.
Repeat this for the other Mounting Bracket and Table Top Mounting Foot.
Once you have the Table Top Mounting Feet securely fastened to the
Mounting Brackets, it is now time to mount them to the TSB3.0. Align
the center of the cross section on the Mounting Bracket with the center of
mounting holes on the rear of the speaker and fasten using the supplied
Table Top Mounting Screws for each bracket.
Note:
When mounting the table top brackets, fasten the brackets to the far
end mounting holes on each side of the speaker cabinet.
[FIGURE 4]
OFF
ON
EVT
[FIGURE 6]
With emblem removed
[FIGURE 5]
STEP 4
Since the TSB3.0 speaker performs as the front three speakers in a home
theater system they are to be used and set up as you would any normal 5.1
to 7.2 surround sound system for balance and level adjustments. For the
best performance, the amplifier should be set to the small speaker mode
for the left/center/right front speakers. The subwoofer setting should be set
between 80 - 100 Hz. We recommend the use of our Phase Technology
®
subwoofers and surround speakers to complement your TSB3.0.
STEP 5
The EVT
™
switch
(Figure 6)
, located on the front of the speaker under
the Phase Technology emblem on the grille, activates Phase Technology’s
Enhanced Voice Technology feature. This feature is designed to improve
the clarity of the voice or dialogue from the center channel speaker in the
system. Flipping the switch to the on position (right) engages the circuit
and off position (left) turns it off. The emblem can easily be removed and
replaced. Use the tip of a pencil or a small screw driver to engage or turn
off the EVT function.
