4
4. Unpack speaker. Leave paint
mask in place until after speaker
is installed or painting is com-
plete.
1. Nail or screw bracket to joists.
2. Finish installing ceiling.
3. Use RotoZip or other tool to cut
hole. Hole dimensions are 4” H x
4” W.
[CI15 INSTALLATION USING OPTIONAL PRE-CONSTRUCTION BRACKET]
5. Connect Euroblock to speaker
wires and connect to speakers.
6. If required, attach seismic re-
straint system to hole in clamping
arm, then to reinforced structure
(saftey cable not included)
7. Insert speaker into mounting
hole with paint mask in place.
Tighten both screws on the baffle
face to actuate the mounting
wings. Firmly secure both screws.
DO NOT OVERTIGHTEN.
8. Remove paint mask unless
painting is required. In that case,
follow steps 9-12 when painting is
complete.
9. Adjust tap switch to proper
setting. Switch is preset to 8 Ohm
mode.
10. Attach grille safety clip by
placing the large end of the clip
over snap-fit post (1), then sliding
clip until small end snaps into
place around post (2).
11. Align tabs on snap-fit grille
with slots in baffle. Gently press
grille into place.
12. DONE!
1.
2.
[CARING FOR YOUR PHASE TECHNOLOGY SPEAKER]
All Phase Technology speakers are finished with a high degree of craftsmanship in either hand polished paint or vinyl laminates. We recommend using a
lint-free rag with a small amount of glass cleaner to maintain the long-lasting beauty of the finish. Avoid products containing silicones, oils, oil derivatives,
or solvents. Enclosures finished in vinyl laminates may be cleaned with a damp cloth as necessary.
[MAINTENANCE AND SERVICE]
Because of Phase Technology’s uncompromising quality control programs, it’s unlikely that your speakers will ever need service if connected and used
as outlined in this Owners’ Manual. In the unlikely event that a problem does occur, please contact your Phase Technology dealer. Your dealer has the
necessary factory-authorized parts and trained technicians to quickly restore your speaker to its original performance specifications.
[TROUBLESHOOTING]
NO SOUND
1.
Verify that all components are plugged in and turned on.
