MSD
Programmable Shift Controller
PN 75591
WARNING:
During installation, disconnect the battery cables. When disconnecting, always
remove the Negative cable first and install it last.
Parts Included:
1 – Shift Controller
8 – #10 Screws
10 – Butt Splices
1 – Pro-Data+ Software
4 – #10 Nuts
2 – Ring Terminals
1 – 9-Pin Harness, 10-Feet
4 – #10 Washers
2 – Deutsch Terminated Harnesses
1 – 1-Pin Harness
The optional Hand Held Programmer/Monitor, PN 7550,
connects through the 9-pin connector on the Control and
features an LCD display that allows you to walk through the
programs as well as monitor the engine’s rpm, the current
gear, alerts and more (Figure 1).
There is also a computer disk supplied with the MSD
software. This software is for PCs running windows
95, 98 or NT. All of the adjustable parameters can be reviewed
and set, then uploaded to the Controller. More information
on using this software begins on page 5.
The MSD Programmable Shift Controller allows you to
program different rpm points to trigger the shift solenoids.
Any transmission configuration may be used up to a six
speed trans. Programming the rpm and options of the Shift
Controller can be done with MSD’s Hand Held Monitor, PN
7550, or with the MSD Pro-Data+ Software on a Windows
based PC.
Note:
Solid core spark plug wires cannot be used with this controller.
Figure 1 Hand Held Programmer, PN 7550.
