4.3
Attach V-SHOCK EDGE PFLs to Harness Using V-SHOCK EDGE Pin Connector
The V-SHOCK EDGE PFL pin connector allows connection to a full body harness just below the rear D-Ring or through the
PFL tunnel.
1. If harness has PFL tunnel—use PFL tunnel as
connection point.
If harness does not have PFL tunnel—Lift D-ring on
harness and pull straps through dorsal pad until
V-SHOCK EDGE pin connector can feed between
webbing straps and dorsal pad.
2. Pull knurled knob on right side of pin connector.
Rotate clockwise. Pull harness connector pin on
right to open pin connector.
3. Feed pin through PFL tunnel or behind both straps on
harness.
4. If harness has PFL tunnel— Installation complete.
If harness does not have PFL tunnel— Pull harness
straps back through dorsal pad to eliminate slack in
webbing.
11
V-SHOCK® & V-SHOCK® EDGE
Personal Fall Limiter (PFL)
US
US
4 Harness Attachment
