MSA PrimaX IR, Operating Manual

Page: 33 / 44

PrimaX® IR
33
Accessories
GB
7 Accessories
The following accessories are available for the device:
7.1 Flow Cap
Fig. 23 Flow cap
The flow cap is for use with a sampling system. It is available in 316 stainless steel and is secured to
the sensor in place of the environmental guard with two screws.
A 3-way pushbutton valve is available for ease of calibration when using the flow cap. The sample flow
and the calibration gas can both be plumbed to this valve, and the operator holds down the pushbutton
to switch the flow to the calibration gas.
Use a gas flow rate of 1.5 l/min when using the flow cap to achieve the response times stated in
chapter 6.
Description Part No.
Calibration cap 10111874 Fig. 1
Aluminum junction box kit
(Includes mounting bracket) 10117607 – NPT
10117606 – M25
Chapter 3.1
316 stainless steel junction box kit
(Includes mounting bracket) 10117608 – NPT
10117609 – M25
Fig. 1
Insect screen/Remote calibration inserts 10116419 Chapter 7.5
Sun shield 10113481 Chapter 7.2
HART calibration cover / Bump Cap 10122228 Fig. 8
HART hand-held communicator cable 10081441 Fig. 9
Remote HART Calibration Kit 10122783 Fig. 16, Fig. 28
1.5 LPM Flow Regulator 478358
Flow cap 10113100 Chapter 7.1
3-way pushbutton valve 635729 Chapter 7.1
Sensor O-ring 10105967
Environmental guard 10113663 Fig. 1
Stainless steel tether 10114097 Fig. 12
Duct mount kit 10114373 Chapter 7.3
HART Junction Box
10119594 - M25
10119593 - NPT
Chapter 7.4