USER INSTRUCTIONS
LYNX TRIPOD
Page 13
Copyright © 2002, MSA
P/N 10022053
Step 3:
Position the feet about the hatch cover in
accordance with work area geometry and
surface conditions.
Step 4:
Optional components such as the Split-Mount Pulley
or the Dynevac with leg-mount bracket should be
assembled to the Lynx Tripod at this time. Follow the
appropriate user instructions for each optional
component that is to be connected to the Lynx
Tripod.
Step 5:
Raise the Lynx Tripod one leg at a time by pulling
the positive-locking pin (attached to the upper leg
section), incrementally sliding out the lower leg
section, and repinning. Repeat for each leg un-
til the Lynx Tripod head is at the desired height.
Each leg may be extended to different lengths to
accommodate variations in surface elevation.
The Lynx Tripod head should be horizontal when
installation is complete. Be careful not to
extend each leg too far in each increment so
as to cause the Lynx Tripod to topple.
