ON
1 2 3 4 5 6 7 8
1
Presence
Timer
5
Self
Diagnostic
3
Frequency
2
Pattern Depth
(Rows)
4
Monitor
Mode
Sensor's
Cable
Connection
Cable
Red & Black = Power [Nonpole]
Yellow
= Normally Open [NO]
Green
= Normally Closed [NC]
White
= Common
4. Connect wiring. Push amp connectors tightly
together.
5. Place connector in holder.
6. Set desired sensor parameters as noted in Sections
5 & 7.
7. Place cover on sensor and clean the sensor.
NOTE: For maximum pattern depth and width,
mount the DH94D as high as possible and use
the
maximum
pattern
angle
(5º).
Section 5
Dip Switch Settings
1
Presence Timer:
Delay is adjustable using dip
switches 1 & 2. The DH94D will detect a stationary
object only for the time period set by the Presence
Timer. The timer will reset and begin if any
movement
is
detected.
2
Pattern Depth (Rows):
To adjust the pattern depth,
set switch 3 & 4 as shown.
3
Frequency:
When more than two sensors are used
in close proximity to each other, to prevent
interference use alternate frequency settings. (H +
MH + ML + L = Maximum 4 sensors).
4
Monitor Mode:
A snow mode is available using
switch 1. Snow Mode should only be used in
environments with heavy snowfall or other extreme
conditions.
5
“ON”:
When power is first supplied to the sensor, the
DH94D performs self-diagnostics.
Section 6
Power
BEFORE APPLYING POWER, READ AND FOLLOW THESE
INSTRUCTIONS:
When power is applied, the sensor will read and store the
environmental optical parameters. This is necessary for
Presence Detection to work properly.
1. CLEAR THE AREA OF ANY UNNECESSARY OBJECTS.
2. Apply
POWER.
3. Vacate the Detection Pattern immediately. While the
sensor sees ANY moving objects in its DETECTION
PATTERN, it will not proceed to the following step.
4. DO NOT enter DETECTION PATTERN for 10 seconds
(Presence
Detection
Setting).
5. TEST the presence feature, especially near the door.
DH94D
Sliding Pedestrian Door Presence Sensor
INSTALLATION INSTRUCTIONS
8701 Castle Park Drive
Indianapolis, Indiana 46256
Telephone: (800) 842-2545/(317) 842-2545
www.mssedco.com
Page 2
(/MANU) DH94Dv1105
5. DIP Switch Settings
7. Adjusting Detection Pattern
!